例句與造句

1. Typically, that backing sheet also holds a number of binding posts.
2. Today, they have largely been supplanted by binding posts.
3. Wires were wrapped by hand around binding posts or spade lugs and then soldered.
4. A binding post contains a central threaded metal rod and a cap that screws down on that rod.
5. It has two external binding post terminals for the coil and two binding post terminals for the contacts.
6. It's difficult to find binding posts in a sentence. 用binding posts造句挺難的
7. It has two external binding post terminals for the coil and two binding post terminals for the contacts.
8. To accept the wire connection, the loudspeaker enclosure may have binding posts, spring clips, or a panel-mount jack.
9. An " almost identical " audiophile version dubbed, stripped of tone controls and with higher quality loudspeaker binding posts, was released.
10. This creates a bus bar for power distribution, and so may also include a master input connector, usually binding posts or banana connectors.
11. Inside, the more expensive Virtue Two includes upgraded Auricap input capacitors, a higher output chip, larger power caps and copper binding posts and ships with a larger power supply.
12. But this also impaired safety as two wires or pin connectors could be inserted from opposite sides of two binding posts and the tips of the wires or probes might inadvertently short together.
13. In the past, it was common for multiple five-way binding posts to have their drilled holes lined up; this provided convenience in some applications as a bare wire could be strung from post to post to post.
14. Other typical components are a spider or damper, used as the rear suspension element, simple terminals or binding posts to connect the audio signal, and possibly a compliant gasket to seal the joint between the chassis and enclosure.
15. Many speakers and electronics have flexible five-way binding posts that can be screwed down or held down by a spring to accept bare or soldered wire and pins or springy banana plugs ( through a hole in the outward-facing side of the post ).
16. At the instant when the coil current is turned on, or off, there is a brief ( maybe 50 mS ? ) interruption in continuity ( depending on adjustments ) while the moving contact is making the transition from terminal A to terminal B . Otherwise, ( obviously ) there is always continuity between the contact binding post terminals whether the coil is energized or not.
更多例句：  下一頁